POE extender, up to 100 meters, RJ45
Power over Ethernet - No Additional Power Source Required
Extend a POE signal max. 100m over a single CAT cable (cat 5 or higher)
Splitter for PoE via Ethernet cable
LAN with PoE in, gives LAN without PoE out
12 VDC 2A or 24 VDC 1A next to other equipment
12/24 V POE Splitter.
Use the network cable as voltage source for network equipment without PoE.
With this splitter avoids separate power supplies for Access Points, surveillance cameras and other network equipment without PoE Support. By using a PoE switch or an "injector" you can settle for a single network cable that both transfers data and voltage between the switch and the connected network equipment. The splitter has two outputs - one for transferring data via network cable and a DC voltage output to supply the connected equipment.
Power over Ethernet - No Additional Power Source Required
Extend a POE signal max. 100m over a single CAT cable (cat 5 or higher)
IP67 and IK10 Gbit PoE injector for outdoor mounting
PoE++ (60W) injector for PoE equipment
1 x RJ45 port for PoE++ out Data+PoE
1 x RJ45 port Data in
1 x Phoenix connector for the input voltage
DC24V 72W input
DC36V 71W input
DC54V 66W input
PoE standard: IEEE 802.3at/bt (PoE++)
PoE out Mid-span / End-span
Operating temperature: -40 - +75°C
Wall bracket
Dimensions: 170 x 73 x 44 mm
Weight: 425
Gigabit PoE splitter for indoor mounting
PoE++ (60W) Splitter with optional DC output to non-PoE equipment
DC output: 12VDC / 5A or 19VDC / 3.2A or 24VDC / 2.5A
1 x RJ45 port to PoE++ in from Switch or PoE injector
1 x RJ45 port (data) to non-PoE equipment
1 x DC Jack connector (5.5 / 2.5mm) for equipment
POE Standard: IEEE 802.3 at / bt (PoE++)
IEEE 802.3at (PoE+ Mid-Span)
IEEE 802-3bt (PoE++ Poh HDbaset)
Operating temperature: 0 - +50°C
Wall bracket
Size: 94 x 70 x 39 mm
Weight: 265g
PoE adapter
DC injector / splitter cable
Supports 5/12/24 / 48V
Range: Up to 40m
Dimensions DC plug: 5.5 / 2.1mm
Length cable : 15cm
Set of 2 pcs. cables - injector and splitter