Antenna adapter, N-type female - female
Antenna adapter with N-type connector, female - female
used for collection of cables with N male
The Coaxial cable was born in 1880 and is a type of electrical cable having an inner conductor surrounded by a tubular insulating layer, surrounded by a tubular conductive shield.
All coax cables also has an insulating outer sheath or jacket. A coaxial cable is a transmission line used to carry high frequency electrical signals with low loss. It is used for broadband network cabling, cable television signals and connects...
The Coaxial cable was born in 1880 and is a type of electrical cable having an inner conductor surrounded by a tubular insulating layer, surrounded by a tubular conductive shield.
All coax cables also has an insulating outer sheath or jacket. A coaxial cable is a transmission line used to carry high frequency electrical signals with low loss. It is used for broadband network cabling, cable television signals and connects the radio transmitters / receivers for their antennas.
This is very important that a coaxial cable is made from high-quality materials, as 100% pure copper and that the tubular insulating material provides high isolation, and here is foam-isloator best.
it is important that a coaxial cable is as short as possible as it works signaldæmpene. A coaxial cable for radio transmitters is 50 ohms - the resistance is called impedance and should be appropriate for the radio transceiver - opposite the device (eg. An antenna) must be designed with the same resistance. Possibly. mismatch will provide reflections of the cable and destroy / interfere with signal transmission. Video Signal transmission should the impedance is 75 ohm (RG59)
A transmitter and receiver sees a coaxial cable which many complex passive components - capacity between conductor and shield, coils in series, and an ohmic resistance (loss in copper) .
a loss in a coaxial cable applies to both transmitter and receiver. A powerful coaxial cable for example. LLC400 (10mm thick) provides approximately 22dB loss per 100meters at 2.4GHz (WiFi). A LCC200 (5mm thick) gives a loss of some 100meters per 55dB at 2.4GHz. Remember to compensate Coax cable loss with passive Gain antenna if possible. Avoid any active 2-Wejs signal amplifiers.
Remember: Good quality cable offers the best connection.
Subcategories
There are 87 products.
Antenna adapter with N-type connector, female - female
used for collection of cables with N male
RP-SMA female / RSMA female to TS9 male converter
Adapter TS9 male plug to RSMA female - RF connector straight
Antennekabel, N-type hun til SMA han, 10 m LLC400 kabel
Low loss coax cable with N-male/male
Low loss at 10 meters: 2.2dB at 2.4GHz
LLC400, diameter approx. 1 cm
N-male to N-male
Good and robust cable
Always vulcanize joints - outdoors
Length: 1 meter
Adapter, N-type han til N-type hun, 90° vinklet
Coaksialkabel/ adapter SMA(F) til MMCX(RA) 100mm
RG62 Coaxial kabel til ARECnet med BNC han og BNC han stik
93Ω
Sort
Antenna cable with low loss for WIFI and GSM/LTE
N-male and N-female
Loss per 10 meters at 2.4GHz: 2.2dB
Extends cable
Good and robust cable
HDF400
50 Ohms
Always vulcanize antenna joints - outdoors
Black
10 meters
Low loss coax cable with N-male/female
Low loss at 10 meters: 2.2dB at 2.4GHz
LLC400, diameter approx. 1 cm
N-male to N-female
Good and robust cable
Always vulcanize joints - outdoors
Length: 15 meters
Antenna adapter
nut + hole (SMA)
exterior thread + hole (TNC)
Antenna adapter with N-type connector, Han-he is used eg. For direct mounting of antenna on AP
Converting cable from CRC9 to N
Suitable for connection of external antenna for router
RG174, 50 Ohm
100dB per 100meter at 2GHz
CRC9 male
N male
2 meters
Converting cable from CRC9 to N
Suitable for connection of external antenna for router
RG174, 50 Ohm
100dB per 100meter at 2GHz
CRC9 male
N male
5 meter
RG62 Coaxial kabel til ARECnet med BNC han og BNC han stik
93Ω
Sort
SMA adapter
exterior thread + tap
Inside thread + tap
SMA adapter
nut + pin at both ends
Antenna connector adapter from TNC male to SMA male
Some LTE Routers have RTNCF connectors.
Transition connector for the more flexible antenna cable with SMA
Coax cables with SMA are for short lengths to minimize losses
50 OHM impedance
Standing wave ratio: 1:1.15
Frequency range: DC to 3GHz
Impedance 50ohm
MCX male
SMA female
15cm length
Coax cable with N-male/male
Loss at 10 meters: 5.5dB at 2.4GHz
LLC200, diameter approx. 0.5 cm
N-male to N-male
Good and robust cable
Always vulcanize joints - outdoors
Length: 5 meters
RSMA han til SMA hun
Nut + hole
Outside thread + hole