RSMA female / SMA male adapter - SMA cable adapter for WLAN and GSM
SMA adapter
exterior thread + tap
Inside thread + tap
The Coaxial cable was born in 1880 and is a type of electrical cable having an inner conductor surrounded by a tubular insulating layer, surrounded by a tubular conductive shield.
All coax cables also has an insulating outer sheath or jacket. A coaxial cable is a transmission line used to carry high frequency electrical signals with low loss. It is used for broadband network cabling, cable television signals and connects...
The Coaxial cable was born in 1880 and is a type of electrical cable having an inner conductor surrounded by a tubular insulating layer, surrounded by a tubular conductive shield.
All coax cables also has an insulating outer sheath or jacket. A coaxial cable is a transmission line used to carry high frequency electrical signals with low loss. It is used for broadband network cabling, cable television signals and connects the radio transmitters / receivers for their antennas.
This is very important that a coaxial cable is made from high-quality materials, as 100% pure copper and that the tubular insulating material provides high isolation, and here is foam-isloator best.
it is important that a coaxial cable is as short as possible as it works signaldæmpene. A coaxial cable for radio transmitters is 50 ohms - the resistance is called impedance and should be appropriate for the radio transceiver - opposite the device (eg. An antenna) must be designed with the same resistance. Possibly. mismatch will provide reflections of the cable and destroy / interfere with signal transmission. Video Signal transmission should the impedance is 75 ohm (RG59)
A transmitter and receiver sees a coaxial cable which many complex passive components - capacity between conductor and shield, coils in series, and an ohmic resistance (loss in copper) .
a loss in a coaxial cable applies to both transmitter and receiver. A powerful coaxial cable for example. LLC400 (10mm thick) provides approximately 22dB loss per 100meters at 2.4GHz (WiFi). A LCC200 (5mm thick) gives a loss of some 100meters per 55dB at 2.4GHz. Remember to compensate Coax cable loss with passive Gain antenna if possible. Avoid any active 2-Wejs signal amplifiers.
Remember: Good quality cable offers the best connection.
Subcategories
There are 87 products.
SMA adapter
exterior thread + tap
Inside thread + tap
Antenna adapter
nut + hole (SMA)
exterior thread + hole (TNC)
N-type hun, til LLC400-kabelmontage
Løst BNC stik, RG58
N-type han, til LLC400-kabelmontage
T-LED til Ethernet og ARCnet kabler
Antenna adapter with N-type connector, Han-he is used eg. For direct mounting of antenna on AP
Adapter, N-type han til N-type hun, 90° vinklet
Antenna adapter with N-type connector, female - female
used for collection of cables with N male
Adapter, N-type male to N-type female
Adapter, R/SMA hun til R/SMA hun
Transient fuse with N-type male/N-type female connector
Up to 6GHz
Cannot protect against direct lightning strikes
Connect heavy-duty cable between the unit and the nearest ground
50 ohm terminator, typically to ARCnet (BUS-type)
93 W terminator, typisk til ARCnet (BUS-type)
RSMA han til SMA hun
Nut + hole
Outside thread + hole
Antenna cable N-type male for SMA male
Screw + tap for N-male connector
50 ohm
Gold-plated connector
Operating temperature -10 ° to 60 °
0.5 dB loss at 2 GHz
SMA to BNC female he Coax Adapter
BNC female + pin
nut + hole
SMA FEMALE TO SMA FEMALE ADAPTER
exterior thread + hole
exterior thread + hole