BNC male to RCA (RCA) he. Adapter for video signal.
BNC male to RCA / phono Female Adapter
The Coaxial cable was born in 1880 and is a type of electrical cable having an inner conductor surrounded by a tubular insulating layer, surrounded by a tubular conductive shield.
All coax cables also has an insulating outer sheath or jacket. A coaxial cable is a transmission line used to carry high frequency electrical signals with low loss. It is used for broadband network cabling, cable television signals and connects...
The Coaxial cable was born in 1880 and is a type of electrical cable having an inner conductor surrounded by a tubular insulating layer, surrounded by a tubular conductive shield.
All coax cables also has an insulating outer sheath or jacket. A coaxial cable is a transmission line used to carry high frequency electrical signals with low loss. It is used for broadband network cabling, cable television signals and connects the radio transmitters / receivers for their antennas.
This is very important that a coaxial cable is made from high-quality materials, as 100% pure copper and that the tubular insulating material provides high isolation, and here is foam-isloator best.
it is important that a coaxial cable is as short as possible as it works signaldæmpene. A coaxial cable for radio transmitters is 50 ohms - the resistance is called impedance and should be appropriate for the radio transceiver - opposite the device (eg. An antenna) must be designed with the same resistance. Possibly. mismatch will provide reflections of the cable and destroy / interfere with signal transmission. Video Signal transmission should the impedance is 75 ohm (RG59)
A transmitter and receiver sees a coaxial cable which many complex passive components - capacity between conductor and shield, coils in series, and an ohmic resistance (loss in copper) .
a loss in a coaxial cable applies to both transmitter and receiver. A powerful coaxial cable for example. LLC400 (10mm thick) provides approximately 22dB loss per 100meters at 2.4GHz (WiFi). A LCC200 (5mm thick) gives a loss of some 100meters per 55dB at 2.4GHz. Remember to compensate Coax cable loss with passive Gain antenna if possible. Avoid any active 2-Wejs signal amplifiers.
Remember: Good quality cable offers the best connection.
Subcategories
There are 87 products.
BNC male to RCA / phono Female Adapter
T-LED til Ethernet og ARCnet kabler
Antenne RF adapter
FME han til SMA han stik
50Ω
Guldkontakter
BNC-ASSEMBLY is a BNC pass-through with 2. BNC socket. For the assembly of RG58 / 59 or RG62 cable.
Løst BNC stik, RG58
50 ohm terminator, typically to ARCnet (BUS-type)
Gold-plated
Male to
Male lenght about 29mm
Female length: ca. 25mm
Connector Diameter: ca. 3.5 mm | Separation of power: 3-30N
Contact resistance: ≤0.015 Ω
Insulation resistance: ≥100MΩ
RF coaxial coax adapter BNC male to FME male
93 W terminator, typisk til ARCnet (BUS-type)
Antenna adapter, N Female to RPSMA female
SMA: thread + pin
N female
50 Ohm, silver
SMA adapter
exterior thread + tap
Inside thread + tap
Antenna adapter
nut + hole (SMA)
exterior thread + hole (TNC)
RSMA han til SMA hun
Nut + hole
Outside thread + hole
SMA FEMALE TO SMA FEMALE ADAPTER
exterior thread + hole
exterior thread + hole
Adaptor from SMA male to SMA
Nut + rigid
Male thread + hole
SMA adapter
nut + pin at both ends
Coax / BNC antenna cable RG59 male-male
Double Shielded
75 Ohm
Operating temperature: -20 to 75 ° C
Black
Coax / BNC antennekabel RG58 han-han
Dobbeltskærmet
50 Ohm
Driftstemperatur: -20 til 75°C
Sort, PVC