WiFi Gateway for indoor climate alarm - AIRPRO - accessories
REMAINDER SALE
Accessories for AIRPRO climate alarm
WiFi Gateway / Smart Bridge
Max. range is 30 meters
An antenna and USB cable are included
REMAINDER SALE
Indoor air quality monitoring
Measures air pollutant particles
Bluetooth 4.0
Battery: 3.7V, 1500 mAh
Supplied via Micro USB Adapter 5V-1.0A
APP for iPhone 5, 5S, 6, 6+, iOS8 Android 4.3
This version does not have CO2 measurement
Does NOT measure CO2.
AIR PRO S is used for monitoring indoor air quality. AIR PRO S has built-in industrial sensors which stably monitor air pollutant particles (including PM2.5 and PM10) and in addition alcohol, hydrocarbons, amines, CO, CH4, LPG, ketones.
Indoor climate and air quality change frequently. Air quality depends, among other things, on household, electronics equipment, appliances, furniture and lifestyle.
AIR PRO S is a good solution for monitoring your indoor climate, so you can create a healthy environment indoors.
APP for smartphone
AIR PRO S's sensors can record for up to 3 days and the measurements are registered via APP on smartphone. Data is recorded automatically. As a user, air quality can be checked hourly, daily, weekly, monthly, and can also note in the chart for tracking and suggest long-term solution/improvement
Sensors:
Particulate MatterDetectable Particle size > 1.0μ m
Range: 0 - 300 μg/m³
Resolution: 1.0 μg/m³ Detectable Particle size > 1.0μ m
PM2.5/PM10 (μg/m³) Experimental estimation from Sensor output
Range: 0 - 300 μg/m³; Resolution: 1.0 μg/m³ TVOC / Gas Pollution
Detect Total concentration of Volatile Organic Compounds, including Alcohols, Aldehydes, Aliphatic hydrocarbons, Amines, Aromatic hydrocarbons, CO, CH4, LPG, Ketones, Organic acids, etc.
Range: 125 – 3500 PPB; Resolution 1.0 PPB
Resolution: 1.0 PPBCO2N/ANDIR Non-dispersive Infrared Sensor
Range: 400 - 2000 PPM
REMAINDER SALE
Accessories for AIRPRO climate alarm
WiFi Gateway / Smart Bridge
Max. range is 30 meters
An antenna and USB cable are included
Tænd/ sluk enhed via netværk 8 x 230V,forbrugs kwh med relæ styring af alle 8 udgange
Air quality tester that can show if there is gas in the air.
Can be used as a MODBUS RTU sensor, the host can be accessed via RS-485.
1-wire Combi Sensor
Temperature: -20 - +60 ° C +/- 0.6 ° C
Resolution: 0.1 ° C
Humidity (Moisture): 5 -95% Rh +/- 5%
Resolution 0.1%Rh
IP54 Plastic housing, very sturdy
Up to 8 sensors on the same 1-wire
16 bits at temperature
12 bits at moisture
Supply Voltage: 4.5 / 25mW
Dimensions: 74 x 66 x 36 mm
1-axis vibration measurement
Frequency range: 10 Hz to 1K Hz
Amplitude range: ±8g
Data Format:
Acceleration(mg): RMS, Maximum, P-P
Velocity(mm/s): RMS
Top 10 spectrum values(Amplitude/Frequency)
Crest Factor
Supported Modbus RTU Slave protocol
Size: 51 x 30 x 19mm
Supply voltage: 10 - 30VDC
Temp: -25 - +75°C