Network-based device for switching on/off 230 VAC equipment.
Web server built-in - password protected
Can ping a stable IP address and if there is no response - turn equipment off and on
Timetable for on and off - scheduler
Mains socket is SCHUKO
The power supply for 230 VAC devices can be controlled with the NPOWER1+ which is inserted between the power supply and the device. From any PC on the local network (or over the Internet), the relay in the NPOWER1+ can be switched on and off.
The device is operated by entering the IP address of the NPOWER1+ in a Web browser, after which a built-in homepage (web server) appears. It can possibly be used to restart equipment that may be locked, such as routers and PCs. In this way, it is easy to restart, for example, a locked server and with the Watchdog timer function an ADSL cable modem or router, if it does not receive a response from the Internet.
Remote control of 230 VAC supply via local and internet.
10/100 Mbit Ethernet connection with RJ45 connector.
Supports HTTP, TCP/IP, SNMP, DHCP, DDNS and NTP protocols.
NOTE: Rebooting equipment or turning it on/off via the Internet requires a known IP address - either a fixed one or you can use Dynamic DNS (DDNS). This requires that the router supports DDNS, which works in such a way that the router contacts the DDNS provider (e.g. dyndns.dk) and provides its current dynamic IP address, after which the DDNS server associates the dynamic IP address with a fixed web address, e.g. "minkonto.dyndns.dk" or "www.mitdomæne.dk/npower1". To use this function, an account must be created with dyndns.dk or other DDNS providers.
It also requires that the selected port in NPOWER1+ be forwarded to NPOWER1+'s internal IP address in the router.
IEC 320 C14 Male Plug to European CEE 7/7 3Pin Female Socket Power Cord , C14 to EU SCHUKO PDU UPS Cable, 1.8 meter
Open board til smart temperatur- eller fugt måling and styring
Password beskyttet Web baseret konfiguration og kontrol
1 x digital input med “dry contact” og “logic level” mode
1 x analog input fra 0 til 60VDC
1 relæ output med NO/NC kontakter
1-Wire input til 1 temperature eller fugtmåler
SNMP v.1 support
SNMP traps ved alarm
E-mail udsendelse ved alarm
SMTP med godkendelse (SSL/TLS er ikke supporteret)
HTTP og XML API kommandoer
Remote FTP firmware update.
Power distribution device for on and off of 8 x 230vac
monitoring of total power consumption, temperature.
with slave devices Connected: Up to 128 outlets.
The indoor light-gauge, temperature and humidity sensor 3 in 1
For energy optimization and building automation systems
Measuring range of illumination: 0 to 20,000 lux
Temperature Range: -20 to + 60 ° C
humidity Measuring range: 0 to 100% RH
Supports DCON and Modbus RTU / TCP protocols
Supports MQTT protocol Ethernet interface
With RS485 / RJ45 Ethernet communications interface
Relay output - 6 Amp @ 250VAC
Power supply: PoE and 10 - 48VDC, ca. 2 Watt
Operating temperature: 0 - + 75 ° C
web configuration and firmware update via Ethernet
Ceiling Mounting
Track - 20 x 230 V outlet, built-in power consumption meter.
Can be cascaded with nine slaves.
Ethernet password. logo Email alert for exceeding limits and the errors
1-pole relay output - switcher L
