Crimping pliers with cable tester for RJ11, RJ12 and RJ45 network cable and network connector
Cable insulation and crimping cable
Cable termination of RJ11, RJ12 and 8 pins RJ45
Cable review tests with LEDs included
In this category you will see our selection within network testers. See blah. our 'All in One' 'crimpetang to RJ45 with cable tester.
In addition to the lan testers as you see here, please offer Danbit also a fluke tester
In addition to the lan testers as you see here, please offer Danbit also a fluke tester that you can rent.
Did not the test you were looking for, please send us an email at salg@danbit.dk - we will find it for you.
There are 6 products.
Cable insulation and crimping cable
Cable termination of RJ11, RJ12 and 8 pins RJ45
Cable review tests with LEDs included
Tester Cat. 5, 5E, 6 and 7 network cables
Accuracy: ± 2m for cables under 10 meters, ± 5% for cables over 10 meters.
Test length for cables: 1 ~ 300 meters.
Tone Generator: Single / dual digital tone
Operating temperature: 0 ° C - 50 ° C
Storage temperature: -30 ° C - 50 ° C
Humidity: 10% - 90%
Portable Field Strength Meter (100 MHz ~ 6 GHz)
Test the connection for each wire in a network or telephone cable
Battery: 9V (not included)
PoE 802.3 at/af type a/b and non-standard PoE 5~60V
Measurement of cable length (2.5 ~ 200m). Accuracy: ±1.6m
Continuity test: Shows diagram of the conductors in the cable. Range: 600m
With special flash sequence, switch port can be identified
Can show speed on switch port.
Can show auto negotiate on switch.
Scan: Sends a tone over the cable that can be intercepted. Makes it easy to find the right cable, among other cables.
Battery: 3 x AAA, 1 x 9V (not included)
Scan: Sends a tone over the cable that can be intercepted. Make it easy to find the right cable, among other cables.
Review Test: Sends a signal through each manager and shows where the signal comes out at the other end of the cable.
Battery: 2 x 9V (not included)