Test Equipment / Programmer / Logic

DANBIT has a large selection of test equipment and in this category exists;

Fiber tests, cable tests, camera tests, network tests, PoE tests, RS232 tests, screen tester, microscopes, power meter, multimeter, signal strength meter, range finder, thermal camera, universal applications, IC programs, logic analysis and analysis software.

Test Equipment / Programmer / Logic

There are 39 products.

Showing 1-20 of 39 item(s)

Active filters

  • Professional 5" service...

    Professional 5" service monitor for Analog camera setup. Built-in battery. With BNC, HDMI, VGA, 12VDC out

    Portable Service monitor
    AHD / TVI / CVI / CVBS coax in and out, HDMI in, VGA in. PAL / NTSC
    12VDC 1A output for camera
    800 x 480 (5: 3) 5 "TFT color screen.
    Supports Pan-Tilt-Zoom Pelco-D / P PTZ via RS485
    Supply: 5VDC via Micro USB-B connector.
    5200 mAh battery, up to 11 hours battery life
    Suitable for camera installers
    Some IP cameras have CCTV output (BNC)
    Cannot be used for IP cameras without BNC

    Price 1,450.00 DKK
    Product code: MON5-S
    On the way in  
  • Digital multimeter with...

    Digital multimeter with numbers and graphic display, automatic change of measuring range, discontinued model!

    Multimeter with clear multi display
    Note does not have an interface for a PC (although there is a port for it)
    EOL product limited stock
    DC Voltage: 400mV 0.5% +2dgts 4V to 1000V 0.8% +2dgts
    AC Voltage: 4V to 750V 1.5%+3dgts(40~500)
    DC Current: 400 to 400 1.0%+2dgts 20A 2.5% +3dgts
    AC Current: 400 to 4 1.0% + 5dgts(40~500), 40 to 400 1.5% +5dgts(40~500), 20A 3.0% +4dgts(40~500)
    Resistance: 400 to 400, 0.8% +2dgts, 4 1.0% +4dgts
    Capacitance: 4 to 400 2.0% + 5dgts,  4 to 40 3.0% + 5dgts 200 5.0% + 5dgts
    Frequency: 4 to 4 0.1% + 1dgts
    Temperature: -40C ~ 20C 3.0% + 5dgts,  200C ~ 1200C 3.0% + 2dgts
    Logic: Three logic level (Low,---, Hi)
    Continutiy: Buzzer sounds of Resistance less than 800 
    Diode: Yes
    hFE: Yes
    Signal_out: 1 ~ 10 (13 steps)

    Price 300.00 DKK
    Product code: PC-INSTR5USB
    Physically in stock  
  • Cable tester for fiber...

    Cable tester for fiber cables with LC connector. Tester fiber breakage and review. The cable lights up when it is defective

    The fiber cable tester for LC / MU connectors.
    This type of fiber has a tip diameter of 1.25 mm
    Test residue tip suitable for fiber cables with a tip diameter of 1.25mm
    Transmitter visible light through the fiber
    Tester fiber cable with LC connectors at both ends
    Tester Pigtail fiber with LC in one end
    Cable will light up when there is a rupture or crack.
    in a healthy cable the light is seen only in the opposite end of the fiber cable.

    Price 1,383.00 DKK
    Product code: TEST-FIBER-LC
    On the way in  
  • Fiber Cable Tester. Check...

    Fiber Cable Tester. Check fiber cable for breakage and review. The cable lights up where there is a defect. To SC / ST / FC

    Fiber cable tester for SC / FC / ST / E2000 plug types
    The tip of these fiber cables a 2.5mm
    The tester's tip fits fiber ends with a diameter of 2.5mm
    Sending visible light through the fibers.
    In case of fracture, the fiber cable will light up on the spot.
    By healthy cable, light is visible at the opposite end of the fiber

    Price 1,352.00 DKK
    Product code: TEST-FIBER-UNI
    On the way in  
  • Multifunctional network...

    Multifunctional network tester - Test network error

    Tester Cat. 5, 5E, 6 and 7 network cables
    Accuracy: ± 2m for cables under 10 meters, ± 5% for cables over 10 meters.
    Test length for cables: 1 ~ 300 meters.
    Tone Generator: Single / dual digital tone
    Operating temperature: 0 ° C - 50 ° C
    Storage temperature: -30 ° C - 50 ° C
    Humidity: 10% - 90%

    Price 2,500.00 DKK
    Product code: TEST-LAN-M-P
    Physically in stock