max baud rate 115kb / s for 56kb / s for signal RI
Up to 1.7km at 62.5um fiber cable.
Fiber Optic line multimode, 820nm
Transmitting: RxD , TxD, DTR, DSR, RTS, CTS, DCD, RI or 5x RxD, TxD
RS232 signal including DCE / DTE
Time multiplex, full duplex
RS232 DB9 male
Plug fiber ST
overvoltage (soft) protection - supply 600W / 1ms
polarity protected with diodes on DC input
optical indication (LED) red - PWR
Yellow - INPUT signal
Green - OUTPUT signal
Supply voltage 10-30VDC or 9 - 24VAC
power consumption max. 2W
Dimensions: 76 x 55 x 115 mm
RS232 Rxtends up to 250 meters over RJ45 cable Baud rate: 110 ~ 921,600, 8-bit Use STP (shielded) patch cable - straight through The network cable must not be connected to the patch panel 1 x 5VDC/1A - the power supply supplies both devices (PoC) Important: If the distance is long, 2 power supplies are recommended Important: If the network cable is of poor quality, use 2 power supplies
4 x RS485/422 COM ports over fiber, fiber network
Extender over fiber with 4 x RS422 / 485
1 x 100 Mbit fiber
Screw terminal block (5 pole)
SFP slot for 100mbit Multi Mode LC Fiber
62 x 50 x 120 mm
Display 3 LEDs Displays TX / RX, Network and System Status
Supply 9 - 32 VDC (not supplied)
Extend serial cable up to 1600 meters, transiently protected
RS232 / V.24
Transparent data: syncronous and asyncronous
All HW and software handshakes
DB25 male and DB25 female
With screw terminal connection of serial I / O
With RJ45 connection of serial from special cable
DC9V / 2A power supply included
Extend the distance between PC and RS232 Equipment
Straight through network cable
RS232 serial port boost up to 1.2 km
Baud rate range: 300 - 200kbps
Supply voltage: DC9-24V (not included )
Optical isolation
isolation voltage: 2500Vrms pulse or 500 V = continuous
Dimensions: 100 mm x 50 mm x 20 mm
Weight: 350 g