Residual sale

VGA screen tester controls max resolution
34 different patterns
can quick reveal of a monitor is with biiled error

Tester Cat. 5, 5E, 6 and 7 network cables
Accuracy: ± 2m for cables under 10 meters, ± 5% for cables over 10 meters.
Test length for cables: 1 ~ 300 meters.
Tone Generator: Single / dual digital tone
Operating temperature: 0 ° C - 50 ° C
Storage temperature: -30 ° C - 50 ° C
Humidity: 10% - 90%

Fiber cable tester for SC / FC / ST / E2000 plug types
The tip of these fiber cables a 2.5mm
The tester's tip fits fiber ends with a diameter of 2.5mm
Sending visible light through the fibers.
In case of fracture, the fiber cable will light up on the spot.
By healthy cable, light is visible at the opposite end of the fiber

Cable Test Transmitter and receiver for multimode fiber optic

The fiber cable tester for LC / MU connectors.
This type of fiber has a tip diameter of 1.25 mm
Test residue tip suitable for fiber cables with a tip diameter of 1.25mm
Transmitter visible light through the fiber
Tester fiber cable with LC connectors at both ends
Tester Pigtail fiber with LC in one end
Cable will light up when there is a rupture or crack.
in a healthy cable the light is seen only in the opposite end of the fiber cable.

Cable insulation and crimping cable
Cable termination of RJ11, RJ12 and 8 pins RJ45
Cable review tests with LEDs included

Multimeter with capacity measurement
This is a discontinued model and is EOL!
Cannot be interfaced to PC! (although there is a port for it).

Limited stock!

Multimeter with clear multi display
Note does not have an interface for a PC (although there is a port for it)
EOL product limited stock
DC Voltage: 400mV 0.5% +2dgts 4V to 1000V 0.8% +2dgts
AC Voltage: 4V to 750V 1.5%+3dgts(40~500)
DC Current: 400 to 400 1.0%+2dgts 20A 2.5% +3dgts
AC Current: 400 to 4 1.0% + 5dgts(40~500), 40 to 400 1.5% +5dgts(40~500), 20A 3.0% +4dgts(40~500)
Resistance: 400 to 400, 0.8% +2dgts, 4 1.0% +4dgts
Capacitance: 4 to 400 2.0% + 5dgts,  4 to 40 3.0% + 5dgts 200 5.0% + 5dgts
Frequency: 4 to 4 0.1% + 1dgts
Temperature: -40C ~ 20C 3.0% + 5dgts,  200C ~ 1200C 3.0% + 2dgts
Logic: Three logic level (Low,---, Hi)
Continutiy: Buzzer sounds of Resistance less than 800 
Diode: Yes
hFE: Yes
Signal_out: 1 ~ 10 (13 steps)

Portable Service monitor
AHD / TVI / CVI / CVBS coax in and out, HDMI in, VGA in. PAL / NTSC
12VDC 1A output for camera
800 x 480 (5: 3) 5 "TFT color screen.
Supports Pan-Tilt-Zoom Pelco-D / P PTZ via RS485
Supply: 5VDC via Micro USB-B connector.
5200 mAh battery, up to 11 hours battery life
Suitable for camera installers
Some IP cameras have CCTV output (BNC)
Cannot be used for IP cameras without BNC

Loopback testare för RS232 med DB9 honkontakt