BNC - HD SDI female to female coupler
BNC-ASSEMBLY is a BNC pass-through with 2. BNC socket. For the assembly of RG58 / 59 or RG62 cable.
The Coaxial cable was born in 1880 and is a type of electrical cable having an inner conductor surrounded by a tubular insulating layer, surrounded by a tubular conductive shield.
All coax cables also has an insulating outer sheath or jacket. A coaxial cable is a transmission line used to carry high frequency electrical signals with low loss. It is used for broadband network cabling, cable television signals and connects...
The Coaxial cable was born in 1880 and is a type of electrical cable having an inner conductor surrounded by a tubular insulating layer, surrounded by a tubular conductive shield.
All coax cables also has an insulating outer sheath or jacket. A coaxial cable is a transmission line used to carry high frequency electrical signals with low loss. It is used for broadband network cabling, cable television signals and connects the radio transmitters / receivers for their antennas.
This is very important that a coaxial cable is made from high-quality materials, as 100% pure copper and that the tubular insulating material provides high isolation, and here is foam-isloator best.
it is important that a coaxial cable is as short as possible as it works signaldæmpene. A coaxial cable for radio transmitters is 50 ohms - the resistance is called impedance and should be appropriate for the radio transceiver - opposite the device (eg. An antenna) must be designed with the same resistance. Possibly. mismatch will provide reflections of the cable and destroy / interfere with signal transmission. Video Signal transmission should the impedance is 75 ohm (RG59)
A transmitter and receiver sees a coaxial cable which many complex passive components - capacity between conductor and shield, coils in series, and an ohmic resistance (loss in copper) .
a loss in a coaxial cable applies to both transmitter and receiver. A powerful coaxial cable for example. LLC400 (10mm thick) provides approximately 22dB loss per 100meters at 2.4GHz (WiFi). A LCC200 (5mm thick) gives a loss of some 100meters per 55dB at 2.4GHz. Remember to compensate Coax cable loss with passive Gain antenna if possible. Avoid any active 2-Wejs signal amplifiers.
Remember: Good quality cable offers the best connection.
Subcategories
There are 87 products.
BNC-ASSEMBLY is a BNC pass-through with 2. BNC socket. For the assembly of RG58 / 59 or RG62 cable.
SMA extension cable
RP-SMA male to RP-SMA female
nut with internal thread + hole for threading + tap
50 ohm
gold plated connectors
Black
Aerial cable, R / SMA male to SMA male connector
Table type LLC200 coaxial cable (approx. 6mm diameter)
Transmitter + loss to adapter + hole
Antenna adapter with N-type connector, Han-he is used eg. For direct mounting of antenna on AP
Antenna adapter with N-type connector, female - female
used for collection of cables with N male
Coaxial adapter, BNC stik
BNC han til TNC hun stik
Vinklet 90°
Guldbelagte kontakter
Adapter, R/SMA hun til R/SMA hun
Adapter, N-type male to N-type female
Adapter, N-type han til N-type hun, 90° vinklet
93 W terminator, typisk til ARCnet (BUS-type)
Gold-plated
Male to
Male lenght about 29mm
Female length: ca. 25mm
Connector Diameter: ca. 3.5 mm | Separation of power: 3-30N
Contact resistance: ≤0.015 Ω
Insulation resistance: ≥100MΩ
50 ohm terminator, typically to ARCnet (BUS-type)