Z-bracket for Door-magnet mini. To inward door. Extruded aluminum
Mounting bracket Kit. 3 parts
for inward door
Lock force Up to 350 kg
Dim: 260 x 58 x 30 mm
Face plate: 190 x 45 x 13 mm
Voltage: 12VDC / 24VDC
Power consumption: 12V / 500mA / 24V / 250MA
Signal Output NO / NC / COM Lock Status Relay Output
Timer (Delay): 3 / 6 / 9 seconds
Good for wooden door, glass door, metal door, fireproof door
Surface temp: +20℃
Operating temperature -20 - +55℃
humidity 0 ~ 95% (non-condensing)
Surfaces: House Anodized Aluminum
Surfaces Magnet: Zinc
Surfaces Face Plate: Zinc
Weight: 2.7 kg
Door-magnet-yt35 used in normal environments. If IP65 is close and provided with short connection cable. Door-magnet-yt35 can be used with all access control controls that have relay output. The product contains a powerful magnet that "locks" itself stuck to the piece of metal mounted on the door. When there is voltage on Door magnetic Y / 35, the door cannot be opened. When access control is accepted e.g. A password, it will disconnect the power to the magnetic coil and the magnet drops, so that the door can be opened.
Team power with voltage on the spool is up to 350kg.
Different mounting angles can be purchased.
Mounting bracket Kit. 3 parts
for inward door
Timestamp TNA software module for ACCESS RFID KEY and ACCESS RFID WIFI
Mounting angle for DOOR-MAGNET-V8 for outward-facing door. The angle clamp is mounted on the lower edge of the door frame.
It is very important that the anchor plate is mounted floating suspended and that it can come into 100% contact with the holding magnet.
Face creation with RFID and fingerprint reader
Advanced fake finger detection
Touch Keypad and Voice Over IP Doorphone
Max Users: 250,000 (Finger) / 10,000 (face)
Up to 10 million logs And up to 20,000 photos
Resolution: 500 dpi
RFID: 125kHz Em, 13.56MHz Mifare, HID prox
supplied via POE or 12VDC
Dimensions: 149.5 x 207.8 x 45.5 mm
Operating temperature: -20 - + 60 ℃
Technical demanding product - Support hours can be purchased