SMA male / SMA female adapter - SMA adaptor for GSM and WLAN antenna cables
Adaptor from SMA male to SMA
Nut + rigid
Male thread + hole
The Coaxial cable was born in 1880 and is a type of electrical cable having an inner conductor surrounded by a tubular insulating layer, surrounded by a tubular conductive shield.
All coax cables also has an insulating outer sheath or jacket. A coaxial cable is a transmission line used to carry high frequency electrical signals with low loss. It is used for broadband network cabling, cable television signals and connects...
The Coaxial cable was born in 1880 and is a type of electrical cable having an inner conductor surrounded by a tubular insulating layer, surrounded by a tubular conductive shield.
All coax cables also has an insulating outer sheath or jacket. A coaxial cable is a transmission line used to carry high frequency electrical signals with low loss. It is used for broadband network cabling, cable television signals and connects the radio transmitters / receivers for their antennas.
This is very important that a coaxial cable is made from high-quality materials, as 100% pure copper and that the tubular insulating material provides high isolation, and here is foam-isloator best.
it is important that a coaxial cable is as short as possible as it works signaldæmpene. A coaxial cable for radio transmitters is 50 ohms - the resistance is called impedance and should be appropriate for the radio transceiver - opposite the device (eg. An antenna) must be designed with the same resistance. Possibly. mismatch will provide reflections of the cable and destroy / interfere with signal transmission. Video Signal transmission should the impedance is 75 ohm (RG59)
A transmitter and receiver sees a coaxial cable which many complex passive components - capacity between conductor and shield, coils in series, and an ohmic resistance (loss in copper) .
a loss in a coaxial cable applies to both transmitter and receiver. A powerful coaxial cable for example. LLC400 (10mm thick) provides approximately 22dB loss per 100meters at 2.4GHz (WiFi). A LCC200 (5mm thick) gives a loss of some 100meters per 55dB at 2.4GHz. Remember to compensate Coax cable loss with passive Gain antenna if possible. Avoid any active 2-Wejs signal amplifiers.
Remember: Good quality cable offers the best connection.
Subcategories
There are 87 products.
Adaptor from SMA male to SMA
Nut + rigid
Male thread + hole
SMA FEMALE TO SMA FEMALE ADAPTER
exterior thread + hole
exterior thread + hole
SMA han til N-type han RF coax adapter
Kobber/ Guldbelagt
50 Ohm
Adapter, R/SMA hun til R/SMA hun
Adapter, N-type male to N-type female
Low Log antenna cable WiFi, LTE, GSM
HDF400
shielded
50 ohm
N-type He to N-type Han connector
Tab: 0.22db@2.4GHz
Tab: 0.36db@5GHz
black
5 meters
Transient fuse with N-type male/N-type female connector
Up to 6GHz
Cannot protect against direct lightning strikes
Connect heavy-duty cable between the unit and the nearest ground
SMA to BNC female he Coax Adapter
BNC female + pin
nut + hole
Løst BNC stik, RG58
Antenna adapter, N Female to RPSMA female
SMA: thread + pin
N female
50 Ohm, silver
RPTNC male to N-Type male
LLC200A
Loss per 10 meters: 5.5dB at 2.4GHz
Black
5 meters
RPTNC male to N-Type male coax cable of 1 meter
TNC - Round + hole
N - N he
For e.g. Linksys AP, Cisco
LLC200 coax cable
Black
50 ohm terminator, typically to ARCnet (BUS-type)
MMCX type male for N type male connector
30cm RG58, 50 ohm
RF / coaxial adapter / converter connector
SMA to TS9 He
Jack Connector
Silver colored.
Length: Approx. 1.5 cm
T-LED til Ethernet og ARCnet kabler
WLAN antennekabel R/SMA han til N-type han
LLC200, HDF400
50 ohm
Guldbelagte stik
Driftstemperatur -10° til 60°
Sort
Coaxial adapter, BNC stik
BNC han til TNC hun stik
Vinklet 90°
Guldbelagte kontakter
93 W terminator, typisk til ARCnet (BUS-type)