USB to serial (for PCs without COM port)
USB to serial converter where a serial port is not available - for example, on notebooks, note books and desktop PCs / servers. Some versions also have optical isolation, so the equipment is protected from overvoltage and interference.
Supports both Open Host Controller Interface (OHCI) and Universal Host Controller Interface (UHCI). Complies with USB...
USB to serial (for PCs without COM port)
USB to serial converter where a serial port is not available - for example, on notebooks, note books and desktop PCs / servers. Some versions also have optical isolation, so the equipment is protected from overvoltage and interference.
Supports both Open Host Controller Interface (OHCI) and Universal Host Controller Interface (UHCI). Complies with USB specifications.
Note: This type of converter cannot be used with dongles (hardware lock for software) since the COM port appears virtual, which is not accepted by dongles.
Drivers for OS included.
Does not record IRQ, DMA or I / O port - COM ports can be "remapped"
Subcategories
There are 29 products.
Get a COM port on the Android Tablet or Android phone via USB port
Connect 1 x RS232 equipment to Android Tablet / phone
Connect to micro USB port on the Tablet / Phone
Baud rate up to 921.6 kbit / s
Get a COM port on the PC via the USB port
USB to RS232 7 or 8 bit
RS232 signals: DCD, RxD, TxD, DTR, GND, DSR, RTS, CTS, RI
Up to 921.6 kbit/s - FTDI chip
DB9 male
USB-C - Serial RS232 Adapter cable
USB Type C Han to 9-pole RS-232 Han connector with finger screws
Download speed 1 Mbps +
Supports Remote Wake-up and Power MM
1.8 meters
Two 16550 High performance UART (RS232) serial channels
Occupies one PCI or PCIe bus slot
Low Profile PCI Form Factor
Includes Low Profile PCI & Regular size PCI two brackets
Both USB A type and USB pin header connector on board to host connection
One RS232 DB9M and one RS232 10pin RJ45 serial ports on board
Includes one 10pin RJ45 – DB9M Bridge cable for 2nd DB9M port
5VDC Power output from each DB9M Port for POS device use application
2 Jumpers Individually enable / disable 5VDC output for each DM9M Port
On Board Molex mini 4Pin Power connector for sufficient DB9M 5V bus power from PC power supply
Supports 32bit/64bit Windows 7, Vista, XP, 2000, ME, 98SE
