Products

Digital sound via Toslink optical fiber is converted to analogue sound - 3.5mm Jack
Digital sound via Coax cable is converted to analogue sound - 3.5mm Jack
Connect amplifier or headphones to the converter box.
With volume control
Supports SPDIF - 24 bit data
Power supply included 5VDC/1A
Manual switch between Toslink and Coax input

Digital ljud konverter til 2 x analog phono stik

REMAINDER SALE

MiniGBIC / SFP optical transceiver
LC
1310 nm
Up to 50 km single mode

MiniGBIC / SFP+
LC
1310 nm
up to 10 km, single-mode

MiniGBIC / SFP+
10 Gigabit
LC
850 nm
Up to 300 m multimode

Mini GBIC / SFP optical transceiver
LC fiber cables
1310 nm
up to 2 km multimode

Compactflash-kort på SATA-port, till 3 ½ "front mount

Compactflash-kort på SATA-port, med underlagsplattoma

Compactflash-kort på SATA-port, skrivare adapter

Connect RS232 equipment directly to the PS/2 port on the PC.
Converts ASCII characters to HID commands - can be used for data collection.

omvandlare

Adapter print with 2 x 40 and 2 x 44 pin IDE jacks. Connect 2½ "HDD to 3½" cable and visa versa. Power cable for 2½ "w / Molex.

PCIE to PCI converter

PCIE to mini PCIE converter w/SIM card socket

PCI to PCI express converter

Parallel til seriel omformer
Hastighed: 300 -19.200 bit/s
Handshake: XON / XOFF
Forsyning: Strømforsyning medfølger, 9 VAC, 400 mA
CNV-PAR232 er ikke bi-direktionel og kan derfor ikke sende meldinger fra printer til pc om evt. blækstatus, ”end of paper” m.m.

Mini-PCI Type III til PCI Adapter kort/ konverter
1 x Mini-PCI Type III slot
Til 5V eller 3.3V PCI/PCI-X slots
Monteringsbeslag passer til alle standard kabinetter

SATA power adapter. SATA PSU for drives with MOLEX power connectors

Converter connector from a MOLEX (5¼”) power supply to a 6-pin connector. on the PCIE card.

Fra Mini DVI-D (kilden) til HDMI omsætter
Understøtter ikke lyd
Opløsning op til 1920 x 1200
10 cm kabel mellem DVI-D og HDMI stik
Mini DVI-D han og HDMI hun

Mini DVI-D to DVI-D transducer
16 cm cable between MDVI and DVI
Cable contributes to less physical loading of connectors

Support 5V SATA III, SATA II and SATA I Drive and SSD
SATA II 3Gbps Controller Mini Vertical Adapter Card
44 Pin 2.0 mm IDE male connector for 5V DC and ATA signals
PCBA and SATA drives powered by Pin 41 & 42 of IDE connector 5V input
Compliant with Serial ATA 2.6
Jumper setting supports IDE Master, Slave and cable selection modes

CompactFlash card interface for PC IDE bus
Suitable for PCs where the CF card is a disk drive

IEEE1394b bilingual FireWire800 cable, supports FireWire400

IEEE1394b tvåspråkig FireWire800 kabel, understøtter FireWire400

From 1 DisplayPort to 4 HDMI monitors
Horizontal Wide image distributed on 4 SIDE-BY-SIDE monitors
Input: up to 3840 x 2400 dots
Output: up to 1920 x 1200 for each monitor
Power supply included 5VDC / 2A

Compact Flash til 2,5 "hårddisk kabinet

Industriel Compact Flash, 4096 MB

Passiv busskort med 6x PCI, 2x PICMG och 1x ISA

Busskort med 3 x ISA. 4 x PCI, 2 x ISA / PCI

Passiv buss passerar 5x PCI-X och 1 x PICMG 1.2, 2U

6 x ISA

AT supply P8,P9

Can offer from 2 ISA slots to 10 ISA slots. Contact us!

Busskort med 2x PCI, 3x PCI-eX och 1x PICMG 1.3

Passive bus card with 1 x PICMG & 4 x 64 bit PCI

Bus card WITH 3x PCIE (1x), 1x PCIE (16x), 1x PICMG 1.3

Passive bus card with 12x PCI
6 x ISA and 2 PICMG

Passive bus card with 12x PCI-X and 2x ePCI-X.

Passive bus card with 2 x PICMG 1.0 slots, 5 x ISA slots 7 x PCI slots, e.g. for S-IND19”OEM+G.

Passive bus card with 4 x PCI slots, ISA slots 4 x and 6 x PCI-Ex slots

Passive bus card with 12x PCI, 1x ISA and 2x PICMG

Passive bus card with 1 x PICMG1.3, 4 x PCI, 5 x PCIexpress

Max. 1920 x 1200 pixels
1 x KVM Extender Console Unit - Remote module
1 x KVM Extender Computer Unit - Local module
1 x 12V DC Power supply included for remote module
1 x KVM cable ( VGA)
USB (2 on Console Unit, 2 on PC Unit)
Only VGA and USB Mouse / Keyboard Transfer
Does Not Transmit Touch from Monitor
USB is only for mouse and keyboard
For point RJ45 network cable up to 200 meters
with Edid Emulation
2 controls for the same PC
Video adjustment

Icron USB Extension - Local Extender device and Remote Extender device
USB 2.0: Up to 480Mbps
USB 1.1: Up to 12Mbps
1 x USB-B (LEX unit)
1 x RJ45 (LEX unit) to 4 x USB-A (REX device)
1 x RJ45 (REX device)
Dimensions: 100mm x 76mm x 26mm
up to 600mA to each USB port (REX device)
Up to 100 meters above the UTP / STP to 4 x USB - version: USB 1.1 and 2.0
5VDC / 3A PSU (REX device)
Operating temperature: 0 ° C to 50 ° C,

RESTSALG

Icron USB Extension - LOCAL and remote unit
Up to 100 meters over UTP / STP
2 x USB port - Version: USB 1.1 and 2.0
24VDC / 1A PSU incl. the remote unit
PSU kan be connected two LOCAL or remote unit
Support up to 11 USB units from 3 USB Hubs

Icron USB Extension - with LOCAL and remote unit
Up to 100 meters over UTP / STP Cat 5e / 6/7
USB version: USB 1.1 and 2.0
24VDC / 1A PSU incl. the remote unit
Support up to 11 USB devices from three USB Hubs

Extends serial cables up to 1600 meters or printer cables up to 180 meters.

PS / 2, CATx extender - extension
Pull a PS / 2 signal up to 100 meters over a CAT5 / 5e / 6/7 UTP network cable
Consists of a transmitter module and a receiver module
Passive, requires no power
Receiver: 2 x PS / 2 and 1 x RJ45 connectors
Transmitter: 2 x PS / 2 and 1 x RJ45 connectors

Active HDMI Extender to mount between 2 pcs. HDMI cable
Transfer HDMI signal up to 40 meters.
Max length HDMI cable is 20m.
Powered from the HDMI source (5VDC in the plug)

DVI-D Extender with local and remote module up to 50 meters.
Extend DVI-D up to 50 meters via Cat. 6 RJ45 cable
Both units are with DVI-D male
Do not connect network switch
With built-in EDID (emulates monitor)
Power is supplied with 5VDC from the DVI connector on the PC
Can be powered with 5VDC USB Micro
Power consumption at 5VDC is approx. 350mA
External power supply: Purchase additional DC5V with USB A female connector

Sender and receiver for the transfer of DVI signal up to 1.2 km via fiber optics
SC Multi Mode fiber cable PC and monitor
Also transmits audio signals to microphone and speaker
REMAINING STOCK - limited quantity

BNC male to RCA / phono Female Adapter

BNC SDI male to RCA / phono RCA Female Adapter

BNC male connector extends through the two screw clamps.

BNC HD SDI female RCA / phono male Adapter

BNC-ASSEMBLY is a BNC pass-through with 2. BNC socket. For the assembly of RG58 / 59 or RG62 cable.

Bluetooth from PC to the adapter provides RS232 port
External antenna.
Bluetooth 2.0.
With 2 pcs. as back-to-back link
provides connection between 2 COM ports
Wireless transfer of data between serial ports
Up to 100 meters
Antenna connector is RSMA female
Setup via AT commands
Must be powered from 5 - 40VDC via screw terminal
USB mini cable to A male - for power from 5VDC
2 x screw terminal for any external power supply
Is not battery-powered
Use Putty for testing/setup
Help with setup can be purchased additionally

1D wireless barcode scanner with USB RF dongle
wireless row side is typically 30 meters
built-in memory for approx. 400 scans
Supports all common 1D barcodes
Radio Technology: Zigbee

Standard Cell m / M8 x 1,25 Anslutningsgänga; Full belastning = 50 kg

The standard load cell m / M8 x 1.25 thread
S-beam type
Full Load = 5 kg
Maximum load: 7.5kg

Standard cell m / M8 x 1.25 gevind; Full load = 20 Kg

Standard Cell m / M8 x 1.25 thread; Full load = 10 Kg

PLC to DC 12-24V with 12v DC / analog inputs and 8 transistor

GPS-referenced Stratum-1 NTP server

> 10,000 NTP queries per second (approximately 600,000 per minute)

Built-in TCXO (Temperature-Compensated Crystal Oscillator) – ensures continued accuracy in the event of GPS failure

32-channel GPS antenna provides stable reception

Gigabit Ethernet (1GbE) with IPv4 and IPv6

NTP authentication: MD5, SHA1 and SHA256 for high security

Web interface and CLI for configuration and monitoring

RS232 output with timecode

Universal AC/DC power supply

NTP Server - Atomic clock for 19 rack mounting.

Signal from DCF77 in Frankfurt (77.5kHz)

Not recommended in EMC noisy environments.

Rod antenna with 5 meter cable with BNC male

Purchase antenna cable 50 ohm, BNC male/male

Additional purchase BNC-ASSEMBLE

With network port and serial port

1U for rack mounting

Powered from 230VAC.

NTP Server - Atomic clock - radio transmitter in Frankfurt DCF77 signal

77.5kHz receiver. Not recommended in EMC noisy environments

Stand-alone NTP time server

Dynamic IP address from DHCP or manual selection of IP address

Antenna is active ferrite antenna included

LCD display for date and time

Built-in battery back up RTC

Signal strength display

Configuration via Web browser, Windows or Linux tool

Lokal forvarslingslarm til brug til fx olietank med SMS og e-mail

Local forvarslingslarm to use the fx olietank

PLC with 6 analog inputs and 4 relay outputs, DC 12-24V

Mini PLC for DC 12-24V
12 x DC / Analog inputs
8 x transistor outputs

PLC to DC 12-24V with 12 DC/ indgange og 8 relæudgange.

Mini PLC for DC 12-24V
12 x DC / Analog inputs
8 x relay outputs

Mini PLC for AC 110-240AC
12 x analog inputs
8 x relay outputs