32 kanals USB logikanalysator
Protokolanalyse for UART, I2C og SPI, hastighed op til 200 MHz
DANBIT has a large selection of test equipment and in this category exists;
Fiber tests, cable tests, camera tests, network tests, PoE tests, RS232 tests, screen tester, microscopes, power meter, multimeter, signal strength meter, range finder, thermal camera, universal applications, IC programs, logic analysis and analysis software.
Subcategories
There are 39 products.
Protokolanalyse for UART, I2C og SPI, hastighed op til 200 MHz
Cable test transmitter and receiver for single mode fiber optic
Test the connection for each wire in a network or telephone cable
Battery: 9V (not included)
Måling og skriftlig rapport pr. kabel, 50 stk og derover
Måling og skriftlig rapport pr. kabel, 6-49 stk
Måling og skriftlig rapport pr. kabel, 1-5 stk
Very useful tool for servicetekinikeren
Target for consumption on the USB port is borderline.
Portable USB voltmeter with LCD display
3-7V / 50-3500mA / 0-19999mAh < br> Voltage Tester and leave
USB2.0 interface
ESD Armbånd til afledning
Loopback testare för RS232 med DB9 honkontakt
Multimeter with capacity measurement
This is a discontinued model and is EOL!
Cannot be interfaced to PC! (although there is a port for it).
Limited stock!
Measurement range: 0.00-14.00pH
Resolution / accuracy: 0.01pH
Calibration: Automatic 3-point calibration 6.8 & 4.00 & 9.18pH
Temperature: 0-60 ° C
Humidity: 100%
Simple and compact digital multimeter with LCD display
DCV measuring range: 300V, 200V, 20V, 2V 200mV
ACV measuring range: 300V, 200V
DCA measuring range: 200mA, 20mA, 2mA, 200uA
Resistance measuring range: 2MΩ, 200KΩ, 20KΩ, 2KΩ, 200Ω
Diode / Continuity measurement
Battery: 9V (included, not installed)
ESD Bracelet for discharge of static electricity
Scan: Sends a tone over the cable that can be intercepted. Make it easy to find the right cable, among other cables.
Review Test: Sends a signal through each manager and shows where the signal comes out at the other end of the cable.
Battery: 2 x 9V (not included)
Multimeter with clear multi display
Note does not have an interface for a PC (although there is a port for it)
EOL product limited stock
DC Voltage: 400mV 0.5% +2dgts 4V to 1000V 0.8% +2dgts
AC Voltage: 4V to 750V 1.5%+3dgts(40~500)
DC Current: 400 to 400 1.0%+2dgts 20A 2.5% +3dgts
AC Current: 400 to 4 1.0% + 5dgts(40~500), 40 to 400 1.5% +5dgts(40~500), 20A 3.0% +4dgts(40~500)
Resistance: 400 to 400, 0.8% +2dgts, 4 1.0% +4dgts
Capacitance: 4 to 400 2.0% + 5dgts, 4 to 40 3.0% + 5dgts 200 5.0% + 5dgts
Frequency: 4 to 4 0.1% + 1dgts
Temperature: -40C ~ 20C 3.0% + 5dgts, 200C ~ 1200C 3.0% + 2dgts
Logic: Three logic level (Low,---, Hi)
Continutiy: Buzzer sounds of Resistance less than 800
Diode: Yes
hFE: Yes
Signal_out: 1 ~ 10 (13 steps)
Engangsposer, vand- og støvtætte til
ESD jordingsudstyr.
ESD måtte til elektronikarbejde.
500 x 700 x 2mm ESD sikret måtte.
Anbefales at bruge ved PC samling og reparation.
Simple and compact digital pen type multimeter with LCD display
DCV measuring range: 600V, 200V, 20V, 2V 200mV
ACV measuring range: 600V, 200V, 20V, 2V
DCA measuring range: 200mA, 20mA
ACA measuring range: 200mA, 20mA
Resistance measuring range: 20MΩ, 2MΩ, 200KΩ, 20KΩ, 2KΩ, 200Ω
Diode / Connection measurement
Built-in LED lamp
Battery: 2x1.5V AAA (not included)
Dimensions: 225 x 38 x 26 mm
Easy to use
DIP switch for disconnecting and connecting signal (easy to connect external cables/props)
Branch too high signal
Red for low signal
RS232 8 signals DCD, RXD, TXD,, DTR, DSR, RTS, CTS, RI.
Cable insulation and crimping cable
Cable termination of RJ11, RJ12 and 8 pins RJ45
Cable review tests with LEDs included
RS232 signal tester
DB9 male/female connector
Tests: DCD, RXD, TXD, DTR, GND, DSR, RTS, CTS and RI
Standard RS232 DTE and DCE connection
Does not require power supply
PoE 802.3 at/af type a/b and non-standard PoE 5~60V
Measurement of cable length (2.5 ~ 200m). Accuracy: ±1.6m
Continuity test: Shows diagram of the conductors in the cable. Range: 600m
With special flash sequence, switch port can be identified
Can show speed on switch port.
Can show auto negotiate on switch.
Scan: Sends a tone over the cable that can be intercepted. Makes it easy to find the right cable, among other cables.
Battery: 3 x AAA, 1 x 9V (not included)
Cable tester for fiber SC and RJ45
RJ45, RJ11 & SC cable tester
Up to 300m cable length RJ45
Fiber cable tester for SC / FC / ST / E2000 plug types
The tip of these fiber cables a 2.5mm
The tester's tip fits fiber ends with a diameter of 2.5mm
Sending visible light through the fibers.
In case of fracture, the fiber cable will light up on the spot.
By healthy cable, light is visible at the opposite end of the fiber
The fiber cable tester for LC / MU connectors.
This type of fiber has a tip diameter of 1.25 mm
Test residue tip suitable for fiber cables with a tip diameter of 1.25mm
Transmitter visible light through the fiber
Tester fiber cable with LC connectors at both ends
Tester Pigtail fiber with LC in one end
Cable will light up when there is a rupture or crack.
in a healthy cable the light is seen only in the opposite end of the fiber cable.