Remote control / measuring via Ethernet and GSM

Network operated relay box for switching on/off 230 VAC equipment
Shows current power consumption and ambient temperature on PC.
Web server built-in - password-protected.
With IP ping to stable website, it checks network outage.
If there is no response, it turns OFF/ON the desired external equipment.
ON/OFF can be controlled remotely from the browser.
Scheduled ON/OFF
HTTP, TCP/IP, DHCP, DDNS, SNMP v1, SMTP, NTP

The indoor light-gauge, temperature and humidity sensor 3 in 1
For energy optimization and building automation systems
Measuring range of illumination: 0 to 20,000 lux
Temperature Range: -20 to + 60 ° C
humidity Measuring range: 0 to 100% RH
Supports DCON and Modbus RTU / TCP protocols
Supports MQTT protocol Ethernet interface
With RS485 / RJ45 Ethernet communications interface
Relay output - 6 Amp @ 250VAC
Power supply: PoE and 10 - 48VDC, ca. 2 Watt
Operating temperature: 0 - + 75 ° C
web configuration and firmware update via Ethernet
Ceiling Mounting

GSM/3G/4G LTE
2 x digital input, compatible dry contact and wet contact, supports EOL connection;
2 x relay outputs (240VAC@3A)
One relay output can be switched on/off by sending an SMS text
The second relay output can be switched on for 4 minutes if inputs are activated
Supports input status recovery, external power failure alarm via SMS texts
Must be programmed with USB cable to PC
9~36VDC supply voltage and power source output for external device
Up to 3 users can receive alarm and daily report SMS
Up to 5 users can receive alarm calls;
Free SMS APP
Rechargeable backup battery and power monitoring alarm
Metal housing, IP30
Operating temperature: -10 - +70°C
Dimensions: 70 x 88 x 30 mm
Wall installation and DIN
Whip antenna with magnetic base 3m cable included

Temperatursensor til temperaturmåler med 2 meter kabel

Control via SMS messages
Alarm at power failure
Relay output for 230VAC
Universal input for temperature sensor

Network-based device for switching on/off 230 VAC equipment.
Web server built-in - password-protected
Can ping a stable IP address and if there is no response - switch equipment off and on
Timetable for switch on and off - scheduler
Additional mains cable: K-PWR-SHUKO180

Netværksbaseret enhed til tænd/sluk af 230 VAC udstyr. 
Web-server indbygget - password-beskyttet
Kan pinge en stabil IP-adresse (f.eks. Google) og ved manglende svar - slukke og tænde udstyr 

Vandal-proof and waterproof dome antenna
The LTE band 700-2700MHz (including GSM, 3G and 4G)
VSWR: <=1.5
Passive gain: 7-8 dBi
Polarization: Vertical
Nominal power: 50W
Input impedance: 50 Ohm
Cable length: 1.5 meters
Cable type: RG174
Connector type: SMA male
Weight of antenna: 57g
360° Omnidirectional
Center hole mounting

Thermal sensor for mounting incl. 10 m wire

Open board til smart temperatur- eller fugt måling and styring
Password beskyttet Web baseret konfiguration og kontrol
1 x digital input med “dry contact” og “logic level” mode
1 x analog input fra 0 til 60VDC
1 relæ output med NO/NC kontakter
1-Wire input til 1 temperature eller fugtmåler
SNMP v.1 support
SNMP traps ved alarm
E-mail udsendelse ved alarm
SMTP med godkendelse (SSL/TLS er ikke supporteret)
HTTP og XML API kommandoer
Remote FTP firmware update.

1-wire communications - several sensors can be connected to the same unit
± 3.0% relative humidity accuracy
± 0.4% relative temperature accuracy
12 bit resolution for humidity measurement
14 bit resolution for temperature measurement
Calibrated digital output
Eksellent long-term stability
Each sensor has its own unique 64-bit serial number

Water detector with normally closed relay output
Supply voltage: 5VDC / 10mA
Relay contact: max. 30VDC/500mA
Red: +5VDC
Black: GND
Green: Relay contact
White: Relay contact
REMEMBER: Relay contact opens when water is removed.

Temperature sensor with 5 meter cable

Temperature range -40 to 120 ° C

Moisture range 0 to 99% Target 70 x 5 mm

Fits GSM-IO-PWR

1 channel detection of fluid leakage with MODBUS
Shutter local alarm of detection of water leakage
Acoustic alarm - adjustable
RS485 2-wire MODBUS RTU
2 x LED indicators for power and alarm
Relay output for alarm for water leakage - 30VDC / 2A
Monitor cable for liquid detector
Sensor cable can be up to 500 meters
Sensitivity is adjustable
Supports DCON and Modbus RTU protocols
Embedded Dual Watchdog
Operating temperature: -25 to + 75 ° C
Small form factor with DIN bracket
Dimensions: 83 x 70 x 29 mm
Operating voltage: 10 - 30VDC

Temperature gauge
1.8 Meter cable
Dallas DS18B20 Chip

Rest sale

Air conditioning management via mobile phone
Send SMS that simulates IR remote control
Fits for most air-conditioning devices
login to our website and download the manual
manual denotes Models It Supports

Temperature sensor for mounting
10 m wire
Dallas DS18B20 Chip
With copper bracket for vertical mounting (M6, 6mm diameter mounting hole)
Measuring range: -10 to + 85 ° C Accuracy on +/- 1 ° C

GSM 12dBi panel antenne med 1,8 m kabel mål 23 x 9 cm

Vandal-proof GSM dome antenna for metal roof mounting
850-960 / 1770 - 2100 MHz
with 1.5 meter RG 174 Cable
SMA male (rounder + tap)
ABS plastic - With rubber gaskets
Thread hole Ø12 mm