On / off via SMS messages
plugged in socket to GSM 2G network
Setup with phone number
Connects to 230vac
Maximum 10 amp
with Schuko connector
SIM card not included
Switch equipment on/off via SMS messages. Remote control e.g. a server that has gone down or turn on the heat in the cottage.
Telephone relay that plugs into a socket and connects to the GSM (2G) network.
The relay is controlled via SMS messages and calls.
Set up with the phone numbers that must have access to be able to switch the relay output on/off.
Connects to 230 VAC. a maximum of 10 Amp in DK can be drawn through the unit
Built-in relay can handle 230VAC/16Amp, not inductive load.
Comes with schuko plug.
requires a SIM card - not included.
Schuko adapter for Danish plug with earth
1 channel detection of fluid leakage with MODBUS
Shutter local alarm of detection of water leakage
Acoustic alarm - adjustable
RS485 2-wire MODBUS RTU
2 x LED indicators for power and alarm
Relay output for alarm for water leakage - 30VDC / 2A
Monitor cable for liquid detector
Sensor cable can be up to 500 meters
Sensitivity is adjustable
Supports DCON and Modbus RTU protocols
Embedded Dual Watchdog
Operating temperature: -25 to + 75 ° C
Small form factor with DIN bracket
Dimensions: 83 x 70 x 29 mm
Operating voltage: 10 - 30VDC
The indoor light-gauge, temperature and humidity sensor 3 in 1
For energy optimization and building automation systems
Measuring range of illumination: 0 to 20,000 lux
Temperature Range: -20 to + 60 ° C
humidity Measuring range: 0 to 100% RH
Supports DCON and Modbus RTU / TCP protocols
Supports MQTT protocol Ethernet interface
With RS485 / RJ45 Ethernet communications interface
Relay output - 6 Amp @ 250VAC
Power supply: PoE and 10 - 48VDC, ca. 2 Watt
Operating temperature: 0 - + 75 ° C
web configuration and firmware update via Ethernet
Ceiling Mounting
Network-based device for switching on/off 230 VAC equipment.
Web server built-in - password protected
Can ping a stable IP address and if there is no response - turn equipment off and on
Timetable for on and off - scheduler
Mains socket is SCHUKO
Bypass-Switch til udskiftning eller vedligeholdelse af uafbrydelige strømforsyninger (UPS)
19" rackmontering, 1U
Synlig LED-Display
1 output „zur USV“ IEC C13, 10A / IEC C19, 16A
1 input „von USV“ IEC C14, 10A / IEC C20, 16A
4 x IEC C13 udgange 14A
3 x RJ45, LAN og Sensor
1 x IEC C14 10A/ IEC C20 16A Strømforsyning
