DANBIT has a large selection of test equipment and in this category exists;
Fiber tests, cable tests, camera tests, network tests, PoE tests, RS232 tests, screen tester, microscopes, power meter, multimeter, signal strength meter, range finder, thermal camera, universal applications, IC programs, logic analysis and analysis software.
Subcategories
There are 39 products.
Cable Test Transmitter and receiver for multimode fiber optic
Simple and compact digital pen type multimeter with LCD display
DCV measuring range: 600V, 200V, 20V, 2V 200mV
ACV measuring range: 600V, 200V, 20V, 2V
DCA measuring range: 200mA, 20mA
ACA measuring range: 200mA, 20mA
Resistance measuring range: 20MΩ, 2MΩ, 200KΩ, 20KΩ, 2KΩ, 200Ω
Diode / Connection measurement
Built-in LED lamp
Battery: 2x1.5V AAA (not included)
Dimensions: 225 x 38 x 26 mm
PoE 802.3 at/af type a/b and non-standard PoE 5~60V
Measurement of cable length (2.5 ~ 200m). Accuracy: ±1.6m
Continuity test: Shows diagram of the conductors in the cable. Range: 600m
With special flash sequence, switch port can be identified
Can show speed on switch port.
Can show auto negotiate on switch.
Scan: Sends a tone over the cable that can be intercepted. Makes it easy to find the right cable, among other cables.
Battery: 3 x AAA, 1 x 9V (not included)
Multimeter with clear multi display
Note does not have an interface for a PC (although there is a port for it)
EOL product limited stock
DC Voltage: 400mV 0.5% +2dgts 4V to 1000V 0.8% +2dgts
AC Voltage: 4V to 750V 1.5%+3dgts(40~500)
DC Current: 400 to 400 1.0%+2dgts 20A 2.5% +3dgts
AC Current: 400 to 4 1.0% + 5dgts(40~500), 40 to 400 1.5% +5dgts(40~500), 20A 3.0% +4dgts(40~500)
Resistance: 400 to 400, 0.8% +2dgts, 4 1.0% +4dgts
Capacitance: 4 to 400 2.0% + 5dgts, 4 to 40 3.0% + 5dgts 200 5.0% + 5dgts
Frequency: 4 to 4 0.1% + 1dgts
Temperature: -40C ~ 20C 3.0% + 5dgts, 200C ~ 1200C 3.0% + 2dgts
Logic: Three logic level (Low,---, Hi)
Continutiy: Buzzer sounds of Resistance less than 800
Diode: Yes
hFE: Yes
Signal_out: 1 ~ 10 (13 steps)
The fiber cable tester for LC / MU connectors.
This type of fiber has a tip diameter of 1.25 mm
Test residue tip suitable for fiber cables with a tip diameter of 1.25mm
Transmitter visible light through the fiber
Tester fiber cable with LC connectors at both ends
Tester Pigtail fiber with LC in one end
Cable will light up when there is a rupture or crack.
in a healthy cable the light is seen only in the opposite end of the fiber cable.
Multimeter with capacity measurement
This is a discontinued model and is EOL!
Cannot be interfaced to PC! (although there is a port for it).
Limited stock!
Fiber cable tester for SC / FC / ST / E2000 plug types
The tip of these fiber cables a 2.5mm
The tester's tip fits fiber ends with a diameter of 2.5mm
Sending visible light through the fibers.
In case of fracture, the fiber cable will light up on the spot.
By healthy cable, light is visible at the opposite end of the fiber
Måling og skriftlig rapport pr. kabel, 1-5 stk
Programmer til EPROM/EEPROM m.fl. 40 bens sokkel
Fiber tester shows power and loss in a fiber cable
Used as remote unit for TEST-FIBER-PM-LS
Wavelength: 850nm, 1310nm, 1550 nm
Battery: 2 x AAA (included)
Cable test transmitter and receiver for single mode fiber optic
Cable tester for fiber SC and RJ45
RJ45, RJ11 & SC cable tester
Up to 300m cable length RJ45
Måling og skriftlig rapport pr. kabel, 6-49 stk
Måling og skriftlig rapport pr. kabel, 50 stk og derover
Very useful tool for servicetekinikeren
Target for consumption on the USB port is borderline.
Portable USB voltmeter with LCD display
3-7V / 50-3500mA / 0-19999mAh < br> Voltage Tester and leave
USB2.0 interface
Engangsposer, vand- og støvtætte til
ESD Bracelet for discharge of static electricity
ESD Armbånd til afledning
ESD jordingsudstyr.
ESD måtte til elektronikarbejde.
500 x 700 x 2mm ESD sikret måtte.
Anbefales at bruge ved PC samling og reparation.
