Network products / Wifi / PoE / RJ45-Fiber

Layer 3 Managed Switch

8x Gigabit Ports

4x 10Gbps SFP Ports

Supports OSPF, RIP & Static Routing

VLAN, ACL, Syslog and more

Configuration: Console, Telnet/SSH or Web browser

Operating Temperature 0 ~ 50 C

IPv4 & IPv6 Routing

Power using AC cable

Dimensions 280 x 180 x 44mm

Weight 1622g

Dual-band wireless access point

Maximum speed of 5100 Mbps

5 x internal 3dBi antenna (2.4G x 2, 5G x 3)

Max 256 clients

1x POE/WAN Port & 1x LAN Port

Operating temperature: -10~ 55°C

Supports 48VDC POE and 12VDC input

Dimensions: 220 x 225 x 42.5 mm

Weight: 628g

Flexible VPN security solution with fiber capability

Dual-WAN failover and load balancing

4 x 10/100/1000BASE-T RJ45 Ethernet ports

1 x 1000BASE-X SFP slot for WAN interface

1 x USB 3.0 port for system backup and restore

Supports SSL VPN, IPSec, PPTP and L2TP

Stateful Packet Inspection (SPI) firewall

Content filtering for URL blocking

Power requirements: 100-240V AC, 50-60Hz

Max power consumption: 3.7 watts

Metal enclosure, 1U height, dimensions: 330 x 155 x 43.5 mm

Desktop installation or rack mounting options

Long-range LoRa wireless communication (non-LoRaWAN)

RS-485 MODBUS RTU protocol

1x Analog input 0–10V / 0–20mA / 4–20mA / ADC (0–10V)

1x Analog output sync-capable

1x Digital Input High/Low signal detection

1x Digital Output Supports PWM / Latch mode

AES-128/256 encrypted transmission

Rugged IP68-rated waterproof housing

Wide -40°C to 85°C operating temperature

Ideal for industrial, agricultural, and environmental IoT

Low power for remote or battery-powered deployments

Up to 800 meters - Network extender over RJ45 UTP/STP patch cable

PoE is transmitted in cable from PSE to PD

PoE in to RX, PoE out from RX

1 x 10/100Mbit BASE-TX RJ45 with PoE

Data speed: up to 100Mbit auto-optimization

Auto-optimization / auto-MDI/MDI-X

PoE Standard: IEEE 802.3at/af

PoE Output: 48-56VDC from 15.6 to 67 Watts

1 x RJ45 for VDSL + PoE

PoE in (RX) pin 1/2/4/5(+), 3/6/7/8(-)

PoE out (TX) pin:1,2,4,5(+), 3/6/7/8(-)

Distance: 100m w/PoE+, 500m w/PoE, 1000m without PoE

Purchase power supply from 48-56VDC min. 2Amp

Dimensions: 104 x 70 x 30 mm

Data, SMS Applications
Standard AT Commands
Digital Input Channel to reset the System
USB 2.0 and  RS-232
DIN-Rail
Modem sells separatly

Reinforcement: 8dBi
Direction: Omni-directional
Frequency range: 698-960 MHz, 1710-2170 MHz, 2300-2700 MHz
VSWR: < 2.0
Polarization: Linear Vertical
Impedance: 50 ohms
Direction: Omni-directional
Antenna connector: RP-SMA male connector
Net weight: 65g
Operating temperature: -20°С ~ +80°С
Storage temperature: -30°С ~ +85°С
Package: 2 x Antenna with 25 cm cable
NOTE: NOT FOR MPCI-E

Chipset: Broadcom BCM5761

Interface: PCI Express x1 (some versions use x4 or x8)

Network speed: 10/100/1000 Mbps (Gigabit Ethernet)

Port type: 1 x RJ45 (copper)

Controller: NetXtreme Gigabit Ethernet controller

Supported features: PXE boot (Preboot Execution Environment), Wake-on-LAN (WoL)

TCP/UDP/IP checksum offload

VLAN tagging (802.1Q)

MSI-X support (Message Signaled Interrupts)

ACPI (Advanced Configuration and Power Interface)

Drivers available for:

Windows Server

Linux (via kernel or Broadcom driver)

VMware ESXi (depending on version)

Gigabit switch in robust metal housing
10/100 / 1000Mbit
230VAC supply voltage

REMAINING STOCK

DSL/Cable VPN Router

IEEE 802.3,IEEE802.3u

4 x 10/100M Ethernet RJ-45 ports

1 x 10/100M WAN RJ-45 port

1 x RS-232 dial up backup port

DDNS, UPnP

Up to 32 IPSec VPN tunnels

Supply: 12V DC, 1.2A

Unmanaged 10/100Mbps switch

Converts the AUI port to the fiber cable connection.
Only intended for mounting directly on the network card or HUB
part for isolating the PC from the network or against the frame potential; differences between different supply networks
Max. cable lengths: AUI 50 meters, fiber optic 2000 meters
Power supplied from the AUI port that delivers 10 - 15 VDC / 200 mA
Plugs: DB15 male connector for AUI port and ST connector for fiber optic cable

Integrated 10/100/1000 transceiver
Auto-Negotiation with Next Page capability
Supports PCI rev.2.3, 32-bit, 33/66MHz
Supports pair swap/polarity/skew correction
Crossover Detection & Auto-Correction
Wake-on-LAN and remote wake-up support
Microsoft® NDIS5 Checksum Offload (IP, TCP, UDP) and largesend offload support
Supports Full Duplex flow control (IEEE 802.3x)
Fully compatible with IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Supports IEEE 802.1P Layer 2 Priority Encoding
Supports IEEE 802.1Q VLAN tagging
Serial EEPROM
3.3/1.8/1.5V signaling, 5V PCI I/O tolerant
0.15µm CMOS process
Transmit/Receive FIFO (8K/64K) support
Supports power down/link down power saving
Supports PCI Message Signaled Interrupt (MSI)

RJ45/LAN1. Bravo LAN protector

RJ45 LAN port protector for twisted pair ethernet port or twisted apir wired network.

Residual sale

1 x set of PoE injector and splitter
Injector Input: 90-240VAC, Output: 48VDC IEEE802.3AF
Injektior Ports: C6 POWER, RJ45 Data Input, RJ45 Data + PoE Output
Splitter input: PoE 13.5-60VDC, Output: 12VDC
Splitter ports: RJ45 Data + PoE input, RJ45 Data output, 5.5 mm DC Pwer Output

QR8041

Stock clearance Sale

poe data and voltage splitter.
PoE in
switch to 5VDC or 12VDC
Max. Effect 15Watt
Speed: 10 / 100mbit RJ45

Demo Item - Without Packaging or Accessories
Korenix Jetnet 5010g
7 x 10/100 RJ45 Ethernet
3 x 10/100/1000 RJ45 Ethernet / SFP Combo Ports (10/100 / 1000 Base- T, 100 base-eg, 1000 base-x)
supply voltage: 10.5 ~ 60 VDC
Operating temperature: -25 ~ 70 ° C

Compact 5 port Ethernet switch for 100Mbps
Not Managed
Very economical: max. 2 Watt
Supply voltage: 12 - 48VDC
Can also be powered with 24VDC
With redundant voltage input
Dimensions: 104 x 70 x 30 mm
Weight: 255 grams
IP30, metal housing
DIN bracket