Crimping pliers with cable tester for RJ11, RJ12 and RJ45 network cable and network connector
Cable insulation and crimping cable
Cable termination of RJ11, RJ12 and 8 pins RJ45
Cable review tests with LEDs included
DANBIT has a large selection of test equipment and in this category exists;
Fiber tests, cable tests, camera tests, network tests, PoE tests, RS232 tests, screen tester, microscopes, power meter, multimeter, signal strength meter, range finder, thermal camera, universal applications, IC programs, logic analysis and analysis software.
Subcategories
There are 40 products.
Cable insulation and crimping cable
Cable termination of RJ11, RJ12 and 8 pins RJ45
Cable review tests with LEDs included
RS232 signal tester
DB9 male/female connector
Tests: DCD, RXD, TXD, DTR, GND, DSR, RTS, CTS and RI
Standard RS232 DTE and DCE connection
Does not require power supply
PoE 802.3 at/af type a/b and non-standard PoE 5~60V
Measurement of cable length (2.5 ~ 200m). Accuracy: ±1.6m
Continuity test: Shows diagram of the conductors in the cable. Range: 600m
With special flash sequence, switch port can be identified
Can show speed on switch port.
Can show auto negotiate on switch.
Scan: Sends a tone over the cable that can be intercepted. Makes it easy to find the right cable, among other cables.
Battery: 3 x AAA, 1 x 9V (not included)
Cable tester for fiber SC and RJ45
RJ45, RJ11 & SC cable tester
Up to 300m cable length RJ45
Fiber cable tester for SC / FC / ST / E2000 plug types
The tip of these fiber cables a 2.5mm
The tester's tip fits fiber ends with a diameter of 2.5mm
Sending visible light through the fibers.
In case of fracture, the fiber cable will light up on the spot.
By healthy cable, light is visible at the opposite end of the fiber
The fiber cable tester for LC / MU connectors.
This type of fiber has a tip diameter of 1.25 mm
Test residue tip suitable for fiber cables with a tip diameter of 1.25mm
Transmitter visible light through the fiber
Tester fiber cable with LC connectors at both ends
Tester Pigtail fiber with LC in one end
Cable will light up when there is a rupture or crack.
in a healthy cable the light is seen only in the opposite end of the fiber cable.
Portable Service monitor
AHD / TVI / CVI / CVBS coax in and out, HDMI in, VGA in. PAL / NTSC
12VDC 1A output for camera
800 x 480 (5: 3) 5 "TFT color screen.
Supports Pan-Tilt-Zoom Pelco-D / P PTZ via RS485
Supply: 5VDC via Micro USB-B connector.
5200 mAh battery, up to 11 hours battery life
Suitable for camera installers
Some IP cameras have CCTV output (BNC)
Cannot be used for IP cameras without BNC
Residual sale
VGA screen tester controls max resolution
34 different patterns
can quick reveal of a monitor is with biiled error
2.5 1.25mm adapter
SC, ST, FC, LC
400x zoom
3xAAA battery
0.6kg
Laser Safty Filter
Programmer til EPROM/EEPROM m.fl. 40 bens sokkel
Portable Field Strength Meter (100 MHz ~ 6 GHz)
Tester Cat. 5, 5E, 6 and 7 network cables
Accuracy: ± 2m for cables under 10 meters, ± 5% for cables over 10 meters.
Test length for cables: 1 ~ 300 meters.
Tone Generator: Single / dual digital tone
Operating temperature: 0 ° C - 50 ° C
Storage temperature: -30 ° C - 50 ° C
Humidity: 10% - 90%
Fiber tester shows power and loss in a fiber cable
Used as remote unit for TEST-FIBER-PM-LS
Wavelength: 850nm, 1310nm, 1550 nm
Battery: 2 x AAA (included)
Tilsluttes USB porten på pc’en, hastighed op til 250MHz
Fiber Tester. Measures how much loss there is in a fiber cable at the selected wavelength
3 x SFP ports (2 x Light Source, 1 x Power Meter)
SFP modules included:
650mm FP SC SFP
850mm VCSEL SC SFP
1310mm FP SC SFPT
1550mm FP SC SFP
FiTs Meter Module SC 850/1310/1490 / 1550mm
Purchase remote module TEST-FIBER-PM for measuring on mounted fiber cables
USB 2.0
Basic unit without IC adapter
Supports many house types according adapter
Cable Test Transmitter and receiver for multimode fiber optic
Uncooled Microbolometer sensor with 400×300 resolution
25/50 mm motorized focus thermal lens optional
Support 3 temperature measurement rule types (Spot, Line, Area)
Support human and vehicle detection
Smart detection: intrusion, single line crossing, double line crossing, loitering, wrong way, people counting, enter area, leave area
Reliable temperature-anomaly alarm
Temperature measurement: -20°C ~ 150°C (-4°F ~ 302°F)
Power off self-locking, strong wind resistance
Anti-frozen, IP66
Uncooled VOx Micro bolometer with 640×512 resolution
9/15/25/35/50 mm fixed lens optional
Sensitivity ≤40mK
Support temperature monitoring and alarm
Support humanoid/vehicle detection, fire point detection
Intelligent function: intrusion, single line crossing, double line crossing, loitering, wrong way, enter area, leave area
Support 3 temperature measurement rule types (spot, line, area)
Temperature measurement range: -20°C ~ 150°C (-4°F ~ 302°F)
Support DC12V/PoE/AC24V power supply
IP66
Stand alone thematic network PT camera with temperature alarm
17 different color adjustments
Micro SD card 128GB
Monitoring angle: H: H: 15.4 ° V: 11.6 °
can catch fire: 735m distance
Can pick up person: 735m distance
can pick up vehicle: 2255m distance
Can recognize fire: 245m distance
can recognize person: 184m distance
can recognize vehicle 564m distance
Main Stream: D1 @ 25 / 30fps
H.265, H.264, MJPEG
Operating temperature: -40 ° C ~ 60 ° C
RJ-45 (10 / 100Base-T)
Max 10 users
DC12V / POE / AC24V
IP66, metal
Dimensions: 585 × 251 × 502mm
Weight: 22.5Kg (with 50mm lens)